5 Easy Tips for Repairing a Leaky Pipe

repair a leaking pipe

There are many issues that your pipelines come face to face each day and it will only be a matter of time before a certain are succumbs to the damage and create drips and cracks across the body of your water heater. As tempting it is to just ignore a small leakage in the pipe, this will develop overtime and might just be the reason for your plumbing system to fail. Also, it could lead to flooding your home or needing untimely and expensive repairs. Either way, this will lead you to one route alone – breaking the bank trying to put your plumbing system back in order. To avoid that from happening, you must remedy the problem while in the early stages. Here is how you can do that:

Note: Do not forget to turn off the water supply by closing the shut-off valve. This will make your job a ton easier. After that, let your tap run for a couple of minutes until there is absolutely no water left inside the pipes.

 

  • Rub a compound stick on the cracks.

One method to seal the leak and put the damages under control is to use a compound stick and seal the hole or leakage using it. You can purchase this item from your local plumbing or hardware store. However, this solution is not an all-around fix. This is only applicable for those leaks that are still tiny since it is not strong enough to hold up against the pressure of water gushing from larger holes.

 

  • Tighten the joints and connections.

The magnate areas for leakage are usually joints and cupping that have turned loose over time. If this is your problem, all you have to do is grab a plumbing wrench and tighten the joints. Tighten the joints just enough and make sure that you do not overdo it since it can also be the reason for the next leakage and this time, no matter the amount of tightening, the joints will still come loose.

 

  • Use Epoxy pastes.

Upon locating the leaks, wipe down the surface of the pipe dry to make sure that the epoxy sticks to the pipe properly. Then, bring out your epoxy paste and mash it between your hands to flatten it out. This procedure is essential when you are dealing with plastic pipes. This will help the epoxy adhere better to the surface of the pipe. Next, pack the paste into the void that the hole made in the pipe’s surface. To make it stick better, you can also use a putty knife. Leave the epoxy for at least 20 – 25 minutes to let it settle and dry.

 

  • Utilise your hose clamps.

If you do not have c-clamps and rubber lying around your garage, you can go ahead and purchase some from the hardware store near you. First, you have to lay the rubber flat unto the pipe that has a crack or hole. Then, place the clamp around the rubber making sure that you screw it tightly, using the screwing mechanism it come wit, tightly as possible. Be careful to align the rubber with the pipe properly to prevent any water from escaping the pipe.

 

  • Tape the pipe.

With the supply shut off, use an electrical tape to close the minor leaks and cracks in the body of the pipe. Make sure that there is an extra 6 inches along the sides of the leak that you taped as well to be certain that the tape will really hold.

Take note that no matter how effective the following techniques are, these are all temporary remedies. Only enough to make the pipe hold and the damage minimal while you call for professional plumbing assistance.

Contact Us

Book a Job Or Request For Expert Advise

Location